Cisco Catalyst 2960 Software Configuration Manual page 880
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Configuring EtherChannels
Command
Step 4
pagp port-priority priority
Step 5
end
Step 6
show running-config
or
show pagp channel-group-number internal
Step 7
copy running-config startup-config
To return the priority to its default setting, use the no pagp port-priority interface configuration
command. To return the learning method to its default setting, use the no pagp learn-method interface
configuration command.
Configuring LACP Hot-Standby Ports
When enabled, LACP tries to configure the maximum number of LACP-compatible ports in a channel,
up to a maximum of 16 ports. Only eight LACP links can be active at one time. The software places any
additional links in a hot-standby mode. If one of the active links becomes inactive, a link that is in the
hot-standby mode becomes active in its place.
If you configure more than eight links for an EtherChannel group, the software automatically decides
which of the hot-standby ports to make active based on the LACP priority. To every link between systems
that operate LACP, the software assigns a unique priority made up of these elements (in priority order):
•
•
•
•
In priority comparisons, numerically lower values have higher priority. The priority decides which ports
should be put in standby mode when there is a hardware limitation that prevents all compatible ports
from aggregating.
Determining which ports are active and which are hot standby is a two-step procedure. First the system
with a numerically lower system priority and system-id is placed in charge of the decision. Next, that
system decides which ports are active and which are hot standby, based on its values for port priority and
port number. The port-priority and port-number values for the other system are not used.
You can change the default values of the LACP system priority and the LACP port priority to affect how
the software selects active and standby links. For more information, see the
System Priority" section on page 38-19
page
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
38-18
LACP system priority
System ID (the switch MAC address)
LACP port priority
Port number
38-19.
Chapter 38
Configuring EtherChannels and Link-State Tracking
Purpose
Assign a priority so that the selected port is chosen for packet
transmission.
For priority, the range is 0 to 255. The default is 128. The higher
the priority, the more likely that the port will be used for PAgP
transmission.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
and the
"Configuring the LACP Port Priority" section on
"Configuring the LACP
OL-26520-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
