Supported Acl Features; Ipv6 Acl Limitations - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Understanding IPv6 ACLs
•
If you configure unsupported IPv6 ACLs, an error message appears and the configuration does not take
Note
affect.
The switch does not support VLAN ACLs (VLAN maps) for IPv6 traffic.
For more information about ACL support on the switch, see
Note
with ACLs."
You can apply both IPv4 and IPv6 ACLs to an interface.
As with IPv4 ACLs, IPv6 port ACLs take precedence over router ACLs:
•
•
If any port ACL (IPv4, IPv6, or MAC) is applied to an interface, that port ACL is used to filter packets,
Note
and any router ACLs attached to the SVI of the port VLAN are ignored.
These sections describe some characteristics of IPv6 ACLs on the switch:
•
•
Supported ACL Features
IPv6 ACLs on the switch have these characteristics:
•
•
•
•
•
IPv6 ACL Limitations
With IPv4, you can configure standard and extended numbered IP ACLs, named IP ACLs, and MAC
ACLs. IPv6 supports only named ACLs.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
37-2
IPv6 port ACLs
Supported on inbound traffic on Layer 2 interfaces only.
–
Applied to all IPv6 packets entering the interface.
–
When an input router ACL and input port ACL exist in an SVI, packets received on ports to which
a port ACL is applied are filtered by the port ACL. Routed IP packets received on other ports are
filtered by the router ACL. Other packets are not filtered.
When an output router ACL and input port ACL exist in an SVI, packets received on the ports to
which a port ACL is applied are filtered by the port ACL. Outgoing routed IPv6 packets are filtered
by the router ACL. Other packets are not filtered.
Supported ACL Features, page 37-2
IPv6 ACL Limitations, page 37-2
Fragmented frames (the fragments keyword as in IPv4) are supported.
The same statistics supported in IPv4 are supported for IPv6 ACLs.
If the switch runs out of TCAM space, packets associated with the ACL label are forwarded to the
CPU, and the ACLs are applied in software.
Routed or bridged packets with hop-by-hop options have IPv6 ACLs applied in software.
Logging is supported for router ACLs, but not for port ACLs.
Chapter 37
Configuring IPv6 ACLs
Chapter 31, "Configuring Network Security
OL-26520-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
