Cisco Catalyst 2960 Software Configuration Manual page 745
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Chapter 33
Configuring QoS
Figure 33-3
Classification Flowchart
configuration for classification.
IP and
non-IP
traffic
Check if packet came
with CoS label (tag).
Yes
Use CoS
Assign default
from frame.
port CoS.
Generate DSCP from
CoS-to-DSCP map.
Use the DSCP value to
generate the QoS label.
Done
Are there any (more) QoS ACLs
configured for this interface?
Yes
Read next ACL. Is there
a match with a "permit" action?
Yes
Assign the DSCP or CoS as specified
by ACL action to generate the QoS label.
OL-26520-01
Start
Read ingress interface
Trust DSCP or
Trust IP
IP precedence
precedence
(non-IP traffic).
(IP traffic).
No
Generate the DSCP based on
IP precedence in packet. Use
the IP-precedence-to-DSCP
map. Use the DSCP value to
generate the QoS label.
No
No
Assign the default
DSCP (0).
Done
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Trust CoS (IP and non-IP traffic).
Trust DSCP (IP traffic).
Assign DSCP identical
to DSCP in packet.
(Optional) Modify the
DSCP by using the
DSCP-to-DSCP-mutation
map. Use the DSCP
value to generate
the QoS label.
Done
Check if packet came
with CoS label (tag).
Yes
Use the CoS value to
generate the QoS label.
Generate the DSCP by using
the CoS-to-DSCP map.
Understanding QoS
No
Assign the default port
CoS and generate a
DSCP from the
CoS-to-DSCP map.
Done
33-7
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
