Booting A Specific Software Image - Cisco Catalyst 2960 Software Configuration Manual

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Modifying the Startup Configuration

Booting a Specific Software Image

By default, the switch attempts to automatically boot up the system using information in the BOOT

environment variable. If this variable is not set, the switch attempts to load and execute the first

executable image it can by performing a recursive, depth-first search throughout the flash file system. In

a depth-first search of a directory, each encountered subdirectory is completely searched before

continuing the search in the original directory. However, you can specify a specific image to boot up.

Beginning in privileged EXEC mode, follow these steps to configure the switch to boot a specific image

during the next boot cycle:

configure terminal

boot system filesystem:/file-url

copy running-config startup-config

To return to the default setting, use the no boot system global configuration command.

Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE

Enter global configuration mode.

Configure the switch to boot a specific image in flash memory during the

next boot cycle.

For filesystem:, use flash: for the system board flash device.

For file-url, specify the path (directory) and the name of the bootable

Filenames and directory names are case sensitive.

Return to privileged EXEC mode.

Verify your entries.

The boot system global command changes the setting of the BOOT

environment variable.

During the next boot cycle, the switch attempts to automatically boot up the

system using information in the BOOT environment variable.

(Optional) Save your entries in the configuration file.

Assigning the Switch IP Address and Default Gateway

Show Quick Links

Table of Contents

Catalyst 2960-s