Assigning Switch Information - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Assigning Switch Information
The boot loader also provides trap-door access into the system if the operating system has problems
serious enough that it cannot be used. The trap-door mechanism provides enough access to the system
so that if it is necessary, you can format the flash file system, reinstall the operating system software
image by using the Xmodem Protocol, recover from a lost or forgotten password, and finally restart the
operating system. For more information, see the
page 39-2
You can disable password recovery. For more information, see the
Note
section on page
Before you can assign switch information, make sure you have connected a PC or terminal to the console
port, and configured the PC or terminal-emulation software baud rate and character format to match
these of the switch console port:
•
•
•
•
Assigning Switch Information
You can assign IP information through the switch setup program, through a DHCP server, or manually.
Use the switch setup program if you want to be prompted for specific IP information. With this program,
you can also configure a hostname and an enable secret password. It gives you the option of assigning a
Telnet password (to provide security during remote management) and configuring your switch as a
command or member switch of a cluster or as a standalone switch. For more information about the setup
program, see the hardware installation guide.
Use a DHCP server for centralized control and automatic assignment of IP information after the server
is configured.
Note
If you are using DHCP, do not respond to any of the questions in the setup program until the switch
receives the dynamically assigned IP address and reads the configuration file.
If you are an experienced user familiar with the switch configuration steps, manually configure the
switch. Otherwise, use the setup program described previously.
•
•
•
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
3-2
and the
"Recovering from a Lost or Forgotten Password" section on page
9-5.
Baud rate default is 9600.
Data bits default is 8.
If the data bits option is set to 8, set the parity option to none.
Note
Stop bits default is 1.
Parity settings default is none.
Default Switch Information, page 3-3
Understanding DHCP-Based Autoconfiguration, page 3-3
Manually Assigning IP Information, page 3-14
Chapter 3
Assigning the Switch IP Address and Default Gateway
"Recovering from a Software Failure" section on
"Disabling Password Recovery"
39-3.
OL-26520-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
