Cisco Catalyst 2960 Software Configuration Manual page 315

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Configuring IEEE 802.1x Port-Based Authentication

Configuring 802.1x Authentication

To disable multiple hosts on the port, use the no authentication host-mode interface configuration

This example shows how to enable 802.1x authentication and to allow multiple hosts:

Switch(config)# interface gigabitethernet2/0/1

Switch(config-if)# authentication port-control auto

Switch(config-if)# authentication host-mode multi-host

Switch(config-if)# end

This example shows how to enable MDA and to allow both a host and a voice device on the port:

Switch(config)# interface gigabitethernet2/0/1

Switch(config-if)# authentication port-control auto

Switch(config-if)# authentication host-mode multi-domain

Switch(config-if)# switchport voice vlan 101

Switch(config-if)# end

Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE

Show Quick Links

Chapters

Table of Contents

Catalyst 2960-s