Enabling Ip Source Guard - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Configuring IP Source Guard
Enabling IP Source Guard
Begin in privileged EXEC mode.
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
ip verify source
or
ip verify source port-security
Step 4
exit
Step 5
ip source binding mac-address vlan
vlan-id ip-address inteface interface-id
Step 6
end
Step 7
show ip verify source [interface
interface-id]
Step 8
show ip source binding [ip-address]
[mac-address] [dhcp-snooping | static]
[inteface interface-id] [vlan vlan-id]
Step 9
copy running-config startup-config
To disable IP source guard with source IP address filtering, use the no ip verify source interface
configuration command.
To delete a static IP source binding entry, use the no ip source global configuration command.
This example shows how to enable IP source guard with source IP and MAC filtering on VLANs 10
and 11:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# ip verify source port-security
Switch(config-if)# exit
Switch(config)# ip source binding 0100.0022.0010 vlan 10 10.0.0.2 interface
gigabitethernet1/0/1
Switch(config)# ip source binding 0100.0230.0002 vlan 11 10.0.0.4 interface
gigabitethernet1/0/1
Switch(config)# end
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
20-16
Chapter 20
Purpose
Enter global configuration mode.
Specify the interface to be configured, and enter interface configuration
mode.
Enable IP source guard with source IP address filtering.
Enable IP source guard with source IP and MAC address filtering.
When you enable both IP source guard and Port Security by using the ip
verify source port-security interface configuration command, there are
two caveats:
•
The DHCP server must support option 82, or the client is not
assigned an IP address.
The MAC address in the DHCP packet is not learned as a secure
•
address. The MAC address of the DHCP client is learned as a secure
address only when the switch receives non-DHCP data traffic.
Return to global configuration mode.
Add a static IP source binding.
Enter this command for each static binding.
Return to privileged EXEC mode.
Verify the IP source guard configuration.
Display the IP source bindings on the switch, on a specific VLAN, or on
a specific interface.
(Optional) Save your entries in the configuration file.
Configuring DHCP and IP Source Guard Features
OL-26520-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
