Cisco Catalyst 2960 Software Configuration Manual page 683
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Chapter 29
Configuring System Message Logging
Beginning in privileged EXEC mode, follow these steps to change the level and history table size
defaults. This procedure is optional.
Command
Step 1
configure terminal
Step 2
logging history level
Step 3
logging history size number
Step 4
end
Step 5
show running-config
Step 6
copy running-config startup-config
1.
Table 29-3
lists the level keywords and severity level. For SNMP usage, the severity level values increase by 1. For example, emergencies
equal 1, not 0, and critical equals 3, not 2.
When the history table is full (it contains the maximum number of message entries specified with the
logging history size global configuration command), the oldest message entry is deleted from the table
to allow the new message entry to be stored.
To return the logging of syslog messages to the default level, use the no logging history global
configuration command. To return the number of messages in the history table to the default value, use
the no logging history size global configuration command.
Enabling the Configuration-Change Logger
You can enable a configuration logger to keep track of configuration changes made with the
command-line interface (CLI). When you enter the logging enable configuration-change logger
configuration command, the log records the session, the user, and the command that was entered to
change the configuration. You can configure the size of the configuration log from 1 to 1000 entries (the
default is 100). You can clear the log at any time by entering the no logging enable command followed
by the logging enable command to disable and reenable logging.
Use the show archive log config {all | number [end-number] | user username [session number] number
[end-number] | statistics} [provisioning] privileged EXEC command to display the complete
configuration log or the log for specified parameters.
The default is that configuration logging is disabled.
For information about the commands, see the Cisco IOS Configuration Fundamentals and Network
Management Command Reference, Release 12.3 T:
http://www.cisco.com/en/US/docs/ios/12_3/configfun/command/reference/cfr_1g04.html
OL-26520-01
Purpose
Enter global configuration mode.
1
Change the default level of syslog messages stored in the history file and
sent to the SNMP server.
See
Table 29-3 on page 29-10
By default, warnings, errors, critical, alerts, and emergencies messages
are sent.
Specify the number of syslog messages that can be stored in the history
table.
The default is to store one message. The range is 0 to 500 messages.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Configuring System Message Logging
for a list of level keywords.
29-11
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
