Specifying The Mst Region Configuration And Enabling Mstp - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Configuring MSTP Features
•
•
•
Specifying the MST Region Configuration and Enabling MSTP
For two or more switches to be in the same MST region, they must have the same VLAN-to-instance
mapping, the same configuration revision number, and the same name.
A region can have one member or multiple members with the same MST configuration; each member
must be capable of processing RSTP BPDUs. There is no limit to the number of MST regions in a
network, but each region can only support up to 65 spanning-tree instances. You can assign a VLAN to
only one spanning-tree instance at a time.
Beginning in privileged EXEC mode, follow these steps to specify the MST region configuration and
enable MSTP. This procedure is required.
Command
Step 1
configure terminal
Step 2
spanning-tree mst configuration
Step 3
instance instance-id vlan vlan-range
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
17-16
of the MST regions must contain the CST root, and all of the other MST regions must have a better
path to the root contained within the MST cloud than a path through the PVST+ or rapid-PVST+
cloud. You might have to manually configure the switches in the clouds.
Partitioning the network into a large number of regions is not recommended. However, if this
situation is unavoidable, we recommend that you partition the switched LAN into smaller LANs
interconnected by routers or non-Layer 2 devices.
For configuration guidelines about UplinkFast, BackboneFast, and cross-stack UplinkFast, see the
"Optional Spanning-Tree Configuration Guidelines" section on page
When the switch is in MST mode, it uses the long path-cost calculation method (32 bits) to compute
the path cost values. With the long path-cost calculation method, these path cost values are
supported:
Speed
Path Cost Value
10 Mb/s
2,000,000
100 Mb/s
200,000
1 Gb/s
20,000
10 Gb/s
2,000
100 Gb/s
200
Purpose
Enter global configuration mode.
Enter MST configuration mode.
Map VLANs to an MST instance.
To specify a VLAN range, use a hyphen; for example, instance 1 vlan
1-63 maps VLANs 1 through 63 to MST instance 1.
To specify a VLAN series, use a comma; for example, instance 1 vlan 10,
20, 30 maps VLANs 10, 20, and 30 to MST instance 1.
•
For instance-id, the range is 0 to 4094.
•
For vlan vlan-range, the range is 1 to 4094.
When you map VLANs to an MST instance, the mapping is
incremental, and the VLANs specified in the command are added to
or removed from the VLANs that were previously mapped.
Chapter 17
Configuring MSTP
18-12.
OL-26520-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
