Replacing A Failed Command Switch With A Cluster Member - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Chapter 39
Troubleshooting
If you have not configured a standby command switch, and your command switch loses power or fails
in some other way, management contact with the member switches is lost, and you must install a new
command switch. However, connectivity between switches that are still connected is not affected, and
the member switches forward packets as usual. You can manage the members as standalone switches
through the console port, or, if they have IP addresses, through the other management interfaces.
You can prepare for a command switch failure by assigning an IP address to a member switch or another
switch that is command-capable, making a note of the command-switch password, and cabling your
cluster to provide redundant connectivity between the member switches and the replacement command
switch. These sections describe two solutions for replacing a failed command switch:
•
•
These recovery procedures require that you have physical access to the switch.
For information on command-capable switches, see the release notes.
Replacing a Failed Command Switch with a Cluster Member
To replace a failed command switch with a command-capable member in the same cluster, follow these
steps:
Disconnect the command switch from the member switches, and physically remove it from the cluster.
Step 1
Insert the member switch in place of the failed command switch, and duplicate its connections to the
Step 2
cluster members.
Start a CLI session on the new command switch.
Step 3
You can access the CLI by using the console port or, if an IP address has been assigned to the switch, by
using Telnet. For details about using the console port, see the switch hardware installation guide.
At the switch prompt, enter privileged EXEC mode:
Step 4
Switch> enable
Switch#
Enter the password of the failed command switch.
Step 5
Enter global configuration mode.
Step 6
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Remove the member switch from the cluster.
Step 7
Switch(config)# no cluster commander-address
Step 8
Return to privileged EXEC mode.
Switch(config)# end
Switch#
Use the setup program to configure the switch IP information. This program prompts you for IP address
Step 9
information and passwords. From privileged EXEC mode, enter setup, and press Return.
Switch# setup
Continue with configuration dialog? [yes/no]: y
At any point you may enter a question mark '?' for help.
OL-26520-01
Replacing a Failed Command Switch with a Cluster Member, page 39-9
Replacing a Failed Command Switch with Another Switch, page 39-11
--- System Configuration Dialog ---
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Recovering from a Command Switch Failure
39-9
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
