Cisco Catalyst 2960 Software Configuration Manual page 701
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Chapter 30
Configuring SNMP
Command
Step 4
snmp-server group groupname {v1 |
v2c | v3 {auth | noauth | priv}} [read
readview] [write writeview] [notify
notifyview] [access access-list]
Step 5
snmp-server host host-addr
[informs | traps] [version {1 | 2c | 3
{auth | noauth | priv}}]
community-string [notification-type]
Step 6
snmp-server enable traps
notification-types
Step 7
snmp-server trap-source interface-id
Step 8
snmp-server queue-length length
Step 9
snmp-server trap-timeout seconds
Step 10
end
OL-26520-01
Purpose
Configure an SNMP group.
Specify the recipient of an SNMP trap operation.
For host-addr, specify the name or Internet address of the host (the
•
targeted recipient).
(Optional) Enter informs to send SNMP informs to the host.
•
(Optional) Enter traps (the default) to send SNMP traps to the host.
•
(Optional) Specify the SNMP version (1, 2c, or 3). SNMPv1 does
•
not support informs.
(Optional) For Version 3, select authentication level auth, noauth, or
•
priv.
The priv keyword is available only when the cryptographic
Note
software image is installed.
For community-string, when version 1 or version 2c is specified,
•
enter the password-like community string sent with the notification
operation. When version 3 is specified, enter the SNMPv3 username.
The @ symbol is used for delimiting the context information.
Note
Avoid using the @ symbol as part of the SNMP community string
when configuring this command.
(Optional) For notification-type, use the keywords listed in
•
Table 30-5 on page
sent.
Enable the switch to send traps or informs and specify the type of
notifications to be sent. For a list of notification types, see
page
30-13, or enter snmp-server enable traps ?
To enable multiple types of traps, you must enter a separate snmp-server
enable traps command for each trap type.
When you configure a trap by using the notification type
Note
port-security, configure the port security trap first, and then
configure the port security trap rate:
snmp-server enable traps port-security
•
•
snmp-server enable traps port-security trap-rate rate
(Optional) Specify the source interface, which provides the IP address for
the trap message. This command also sets the source IP address for
informs.
(Optional) Establish the message queue length for each trap host. The
range is 1 to 1000; the default is 10.
(Optional) Define how often to resend trap messages. The range is 1 to
1000; the default is 30 seconds.
Return to privileged EXEC mode.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
30-13. If no type is specified, all notifications are
Configuring SNMP
Table 30-5 on
30-15
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
