Cisco Catalyst 2960 Software Configuration Manual page 700
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Configuring SNMP
Table 30-5
Switch Notification Types (continued)
Notification Type
Keyword
Description
port-security
Generates SNMP port security traps. You can also set a maximum trap rate per second. The range
is from 0 to 1000; the default is 0, which means that there is no rate limit.
Note
rtr
Generates a trap for the SNMP Response Time Reporter (RTR). This trap is supported only when
the switch is running the LAN Base image.
snmp
Generates a trap for SNMP-type notifications for authentication, cold start, warm start, link up or
link down.
storm-control
Generates a trap for SNMP storm-control. You can also set a maximum trap rate per minute. The
range is from 0 to 1000; the default is 0 (no limit is imposed; a trap is sent at every occurrence).
stpx
Generates SNMP STP Extended MIB traps.
syslog
Generates SNMP syslog traps.
tty
Generates a trap for TCP connections. This trap is enabled by default.
vlan-membership
Generates a trap for SNMP VLAN membership changes.
vlancreate
Generates SNMP VLAN created traps.
vlandelete
Generates SNMP VLAN deleted traps.
vtp
Generates a trap for VLAN Trunking Protocol (VTP) changes.
Though visible in the command-line help strings, the insertion, and removal keywords are not
Note
supported.
You can use the snmp-server host global configuration command to a specific host to receive the
notification types listed in
Beginning in privileged EXEC mode, follow these steps to configure the switch to send traps or informs
to a host:
Command
Step 1
configure terminal
Step 2
snmp-server engineID remote
ip-address engineid-string
Step 3
snmp-server user username
groupname {remote host [udp-port
port]} {v1 [access access-list] | v2c
[access access-list] | v3 [encrypted]
[access access-list] [auth {md5 | sha}
auth-password]}
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
30-14
When you configure a trap by using the notification type port-security, configure the port
security trap first, and then configure the port security trap rate:
snmp-server enable traps port-security
•
snmp-server enable traps port-security trap-rate rate
•
Table
Purpose
Enter global configuration mode.
Specify the engine ID for the remote host.
Configure an SNMP user to be associated with the remote host created in
Step 2.
Note
30-5.
You cannot configure a remote user for an address without first
configuring the engine ID for the remote host. Otherwise, you
receive an error message, and the command is not executed.
Chapter 30
Configuring SNMP
OL-26520-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
