Etherchannel Port Groups - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Understanding Interface Types
You cannot delete interface VLAN 1.
Note
SVIs provide IP host connectivity only to the system.Beginning with Cisco IOS release 12.2(55)SE, you
can enable routing and configure static routes on SVIs.
Static routing is supported on SVIs only when the switch is running the LAN base image.
Note
SVIs are created the first time that you enter the vlan interface configuration command for a VLAN
interface. The VLAN corresponds to the VLAN tag associated with data frames on an encapsulated trunk
port or the VLAN ID configured for an access port. Configure a VLAN interface for each VLAN for
which you want to route traffic, and assign it an IP address. For more information, see the
Assigning IP Information" section on page
When you create an SVI, it does not become active until it you associate it with a physical port.
Note
EtherChannel Port Groups
EtherChannel port groups treat multiple switch ports as one switch port. An EtherChannel port group
acts as a single logical port for high-bandwidth connections between switches or between switches and
servers. An EtherChannel balances the traffic load across the links in the channel. If a link within the
EtherChannel fails, traffic previously carried over the failed link changes to the remaining links.You can
group multiple trunk ports into one logical trunk port or multiple access ports into one logical access
port. Most protocols operate over either single ports or aggregated switch ports and do not recognize the
physical ports within the port group. The DTP, the Cisco Discovery Protocol (CDP), and the Port
Aggregation Protocol (PAgP) operate only on physical ports.
When you configure an EtherChannel, you create a port-channel logical interface and assign an interface
to the EtherChannel. Use the channel-group interface configuration command to dynamically create the
port-channel logical interface. This command binds the physical and logical ports together.
For more information, see
Dual-Purpose Uplink Ports
Note
Catalyst 2960-S switches do not have dual-purpose uplink ports.
Some switches support dual-purpose uplink ports. Each uplink port is considered as a single interface
with dual front ends—an RJ-45 connector and a small form-factor pluggable (SFP) module connector.
The dual front ends are not redundant interfaces, and the switch activates only one connector of the pair.
By default, the switch dynamically selects the interface type that first links up. However, you can use the
media-type interface configuration command to manually select the RJ-45 connector or the SFP module
connector. For information about configuring speed and duplex settings for a dual-purpose uplink, see
the
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
12-4
Chapter 38, "Configuring EtherChannels and Link-State Tracking."
"Setting the Interface Speed and Duplex Parameters" section on page
Chapter 12
3-14.
Configuring Interface Characteristics
"Manually
12-30.
OL-26520-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
