Manually Assigning Ip Information - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Assigning Switch Information
NVRAM/Config file
Timeout for Config
Config Download
Switch#
You should only configure and enable the Layer 3 interface. Do not assign an IP address or DHCP-based
Note
autoconfiguration with a saved configuration.
Manually Assigning IP Information
Beginning in privileged EXEC mode, follow these steps to manually assign IP information to multiple
switched virtual interfaces (SVIs):
Command
Step 1
configure terminal
Step 2
interface vlan vlan-id
Step 3
ip address ip-address subnet-mask
Step 4
exit
Step 5
ip default-gateway ip-address
Step 6
end
Step 7
show interfaces vlan vlan-id
Step 8
show ip redirects
Step 9
copy running-config startup-config
To remove the switch IP address, use the no ip address interface configuration command. If you are
removing the address through a Telnet session, your connection to the switch will be lost. To remove the
default gateway address, use the no ip default-gateway global configuration command.
For information on setting the switch system name, protecting access to privileged EXEC commands,
and setting time and calendar services, see
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
3-14
buffer size:
32768
Download:
300 seconds
via DHCP:
enabled (next boot: enabled)
Purpose
Enter global configuration mode.
Enter interface configuration mode, and enter the VLAN to which the IP
information is assigned. The VLAN range is 1 to 4094.
Enter the IP address and subnet mask.
Return to global configuration mode.
Enter the IP address of the next-hop router interface that is directly
connected to the switch where a default gateway is being configured. The
default gateway receives IP packets with unresolved destination IP
addresses from the switch.
Once the default gateway is configured, the switch has connectivity to the
remote networks with which a host needs to communicate.
Note
Return to privileged EXEC mode.
Verify the configured IP address.
Verify the configured default gateway.
(Optional) Save your entries in the configuration file.
Chapter 3
Assigning the Switch IP Address and Default Gateway
When your switch is configured to route with IP, it does not need
to have a default gateway set.
Chapter 5, "Administering the Switch."
OL-26520-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
