Cisco Catalyst 2960 Software Configuration Manual page 599
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Chapter 23
Configuring Port-Based Traffic Control
To disable storm control, use the no storm-control {broadcast | multicast | unicast} level interface
configuration command.
This example shows how to enable unicast storm control on a port with an 87-percent rising suppression
level and a 65-percent falling suppression level:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# storm-control unicast level 87 65
This example shows how to enable broadcast address storm control on a port to a level of 20 percent.
When the broadcast traffic exceeds the configured level of 20 percent of the total available bandwidth of
the port within the traffic-storm-control interval, the switch drops all broadcast traffic until the end of
the traffic-storm-control interval:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# storm-control broadcast level 20
Configuring Small-Frame Arrival Rate
Incoming VLAN-tagged packets smaller than 67 bytes are considered small frames. They are forwarded
by the switch, but they do not cause the switch storm-control counters to increment. In Cisco IOS
Release 12.2(44)SE and later, you can configure a port to be error disabled if small frames arrive at a
specified rate (threshold).
You globally enable the small-frame arrival feature on the switch and then configure the small-frame
threshold for packets on each interface. Packets smaller than the minimum size and arriving at a specified
rate (the threshold) are dropped since the port is error disabled.
If the errdisable recovery cause small-frame global configuration command is entered, the port is
re-enabled after a specified time. (You specify the recovery time by using errdisable recovery global
configuration command.)
Small Frame Arrival-Rate is supported by 2960 only.
Note
Beginning in privileged EXEC mode, follow these steps to configure the threshold level for each
interface:
Command
Step 1
configure terminal
Step 2
errdisable detect cause small-frame
Step 3
errdisable recovery interval interval
Step 4
errdisable recovery cause small-frame
Step 5
interface interface-id
OL-26520-01
Purpose
Enter global configuration mode.
Enable the small-frame rate-arrival feature on the switch.
(Optional) Specify the time to recover from the specified
error-disabled state.
(Optional) Configure the recovery time for error-disabled ports to
be automatically re-enabled after they are error disabled by the
arrival of small frames
Enter interface configuration mode, and specify the interface to be
configured.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Configuring Storm Control
23-5
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
