Enabling And Configuring Port Security - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Configuring Port Security
•
•
•
Table 23-3
Table 23-3
Type of Port or Feature on Port
DTP
Trunk port
Dynamic-access port
SPAN source port
SPAN destination port
EtherChannel
Protected port
IEEE 802.1x port
Voice VLAN port
Flex Links
1. DTP = Dynamic Trunking Protocol
2. A port configured with the switchport mode dynamic interface configuration command.
3. A VLAN Query Protocol (VQP) port configured with the switchport access vlan dynamic interface configuration command.
4. You must set the maximum allowed secure addresses on the port to two plus the maximum number of secure addresses
Enabling and Configuring Port Security
Beginning in privileged EXEC mode, follow these steps to restrict input to an interface by limiting and
identifying MAC addresses of the stations allowed to access the port:
Command
Step 1
configure terminal
Step 2
interface interface-id
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
23-12
VLAN, but is not learned on the access VLAN. If you connect a single PC to the Cisco IP phone,
no additional MAC addresses are required. If you connect more than one PC to the Cisco IP phone,
you must configure enough secure addresses to allow one for each PC and one for the phone.
When a trunk port configured with port security and assigned to an access VLAN for data traffic and
to a voice VLAN for voice traffic, entering the switchport voice and switchport priority extend
interface configuration commands has no effect.
When a connected device uses the same MAC address to request an IP address for the access VLAN
and then an IP address for the voice VLAN, only the access VLAN is assigned an IP address.
When you enter a maximum secure address value for an interface, and the new value is greater than
the previous value, the new value overwrites the previously configured value. If the new value is less
than the previous value and the number of configured secure addresses on the interface exceeds the
new value, the command is rejected.
The switch does not support port security aging of sticky secure MAC addresses.
summarizes port security compatibility with other port-based features.
Port Security Compatibility with Other Switch Features
1
2
port
3
4
allowed on the access VLAN.
Purpose
Enter global configuration mode.
Specify the interface to be configured, and enter interface configuration
mode.
Chapter 23
Configuring Port-Based Traffic Control
Compatible with Port Security
No
Yes
No
Yes
No
No
Yes
Yes
Yes
Yes
OL-26520-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
