Cisco Catalyst 2960 Software Configuration Manual page 607
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Chapter 23
Configuring Port-Based Traffic Control
Command
Step 3
switchport mode {access | trunk}
Step 4
switchport voice vlan vlan-id
Step 5
switchport port-security
Step 6
switchport port-security
[maximum value [vlan {vlan-list |
{access | voice}}]]
OL-26520-01
Purpose
Set the interface switchport mode as access or trunk; an interface in the
default mode (dynamic auto) cannot be configured as a secure port.
Enable voice VLAN on a port.
vlan-id—Specify the VLAN to be used for voice traffic.
Enable port security on the interface.
(Optional) Set the maximum number of secure MAC addresses for the
interface. The maximum number of secure MAC addresses that you can
configure on a switch stack is set by the maximum number of available MAC
addresses allowed in the system. This number is the total of available MAC
addresses, including those used for other Layer 2 functions and any other
secure MAC addresses configured on interfaces.
(Optional) vlan—set a per-VLAN maximum value
Enter one of these options after you enter the vlan keyword:
•
vlan-list—On a trunk port, you can set a per-VLAN maximum value on
a range of VLANs separated by a hyphen or a series of VLANs separated
by commas. For nonspecified VLANs, the per-VLAN maximum value is
used.
access—On an access port, specify the VLAN as an access VLAN.
•
voice—On an access port, specify the VLAN as a voice VLAN.
•
The voice keyword is available only if a voice VLAN is configured on
Note
a port and if that port is not the access VLAN. If an interface is
configured for voice VLAN, configure a maximum of two secure
MAC addresses.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Configuring Port Security
23-13
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
