Cisco Catalyst 2960 Software Configuration Manual page 629

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Configuring LLDP, LLDP-MED, and Wired

Location Service

To use wired location service, the switch must be running the LAN Base image.

This chapter describes how to configure the Link Layer Discovery Protocol (LLDP), LLDP Media

Endpoint Discovery (LLDP-MED) and wired location service on the Catalyst 2960, 2960-S, or 2960-C

switch. Unless otherwise noted, the term switch refers to a standalone switch and to a switch stack.

Stacking is supported only on Catalyst 2960-S switches running the LAN base image.

For complete syntax and usage information for the commands used in this chapter, see the command

reference for this release and the "System Management Commands" section in the Cisco IOS

Configuration Fundamentals Command Reference, Release 12.4.

Understanding LLDP, LLDP-MED, and Wired Location Service

The Cisco Discovery Protocol (CDP) is a device discovery protocol that runs over Layer 2 (the data link

layer) on all Cisco-manufactured devices (routers, bridges, access servers, and switches). CDP allows

network management applications to automatically discover and learn about other Cisco devices

connected to the network.

Understanding LLDP, LLDP-MED, and Wired Location Service, page 26-1

Configuring LLDP, LLDP-MED, and Wired Location Service, page 26-5

Monitoring and Maintaining LLDP, LLDP-MED, and Wired Location Service, page 26-11

Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE

C H A P T E R

Show Quick Links

Chapters

Table of Contents

Catalyst 2960-s