Cisco Catalyst 2960 Software Configuration Manual page 636
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Configuring LLDP, LLDP-MED, and Wired Location Service
Beginning in privileged EXEC mode, follow these steps to enable a TLV on an interface:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
lldp med-tlv-select tlv
Step 4
end
Step 5
copy running-config startup-config
This example shows how to enable a TLV on an interface:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# lldp med-tlv-select inventory-management
Switch(config-if)# end
Configuring Network-Policy TLV
Beginning in privileged EXEC mode, follow these steps to create a network-policy profile, configure the
policy attributes, and apply it to an interface.
Command
Step 1
configure terminal
Step 2
network-policy profile profile number
Step 3
{voice | voice-signaling} vlan [vlan-id
{cos cvalue | dscp dvalue}] | [[dot1p
{cos cvalue | dscp dvalue}] | none |
untagged]
Step 4
exit
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
26-8
Chapter 26
Purpose
Enter global configuration mode.
Specify the interface on which you are configuring an LLDP-MED
TLV, and enter interface configuration mode.
Specify the TLV to enable.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the network-policy profile number, and enter network-policy
configuration mode. The range is 1 to 4294967295.
Configure the policy attributes:
voice—Specify the voice application type.
voice-signaling—Specify the voice-signaling application type.
vlan—Specify the native VLAN for voice traffic.
vlan-id—(Optional) Specify the VLAN for voice traffic. The range is 1 to
4094.
cos cvalue—(Optional) Specify the Layer 2 priority class of service (CoS)
for the configured VLAN. The range is 0 to 7; the default is 5.
dscp dvalue—(Optional) Specify the differentiated services code point
(DSCP) value for the configured VLAN. The range is 0 to 63; the default
is 46.
dot1p—(Optional) Configure the telephone to use IEEE 802.1p priority
tagging and use VLAN 0 (the native VLAN).
none—(Optional) Do not instruct the IP telephone about the voice VLAN.
The telephone uses the configuration from the telephone key pad.
untagged—(Optional) Configure the telephone to send untagged voice
traffic. This is the default for the telephone.
Return to global configuration mode.
Configuring LLDP, LLDP-MED, and Wired Location Service
OL-26520-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
