Configuring Local Span - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Chapter 27
Configuring SPAN and RSPAN
Table 27-1
Feature
VLAN filtering
RSPAN VLANs
Configuring Local SPAN
•
•
•
•
SPAN Configuration Guidelines
•
•
•
•
•
•
•
•
•
OL-26520-01
Default SPAN and RSPAN Configuration (continued)
SPAN Configuration Guidelines, page 27-11
Creating a Local SPAN Session, page 27-12
Creating a Local SPAN Session and Configuring Incoming Traffic, page 27-14
Specifying VLANs to Filter, page 27-16
For SPAN sources, you can monitor traffic for a single port or VLAN or a series or range of ports
or VLANs for each session. You cannot mix source ports and source VLANs within a single SPAN
session.
The destination port cannot be a source port; a source port cannot be a destination port.
You cannot have two SPAN sessions using the same destination port.
When you configure a switch port as a SPAN destination port, it is no longer a normal switch port;
only monitored traffic passes through the SPAN destination port.
Entering SPAN configuration commands does not remove previously configured SPAN parameters.
You must enter the no monitor session {session_number | all | local | remote} global configuration
command to delete configured SPAN parameters.
For local SPAN, outgoing packets through the SPAN destination port carry the original
encapsulation headers—untagged or IEEE 802.1Q—if the encapsulation replicate keywords are
specified. If the keywords are not specified, the packets are sent in native form. For RSPAN
destination ports, outgoing packets are not tagged.
You can configure a disabled port to be a source or destination port, but the SPAN function does not
start until the destination port and at least one source port or source VLAN are enabled.
You can limit SPAN traffic to specific VLANs by using the filter vlan keyword. If a trunk port is
being monitored, only traffic on the VLANs specified with this keyword is monitored. By default,
all VLANs are monitored on a trunk port.
You cannot mix source VLANs and filter VLANs within a single SPAN session.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Default Setting
On a trunk interface used as a source port, all VLANs are
monitored.
None configured.
Configuring SPAN and RSPAN
27-11
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
