Recalling Commands; Disabling The Command History Feature; Using Editing Features; Enabling And Disabling Editing Features - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Using Editing Features
Recalling Commands
To recall commands from the history buffer, perform one of the actions listed in
are optional.
Table 2-4
Recalling Commands
1
Action
Press Ctrl-P or the up arrow key.
Press Ctrl-N or the down arrow key.
show history
1. The arrow keys function only on ANSI-compatible terminals such as VT100s.
Disabling the Command History Feature
The command history feature is automatically enabled. You can disable it for the current terminal session
or for the command line. These procedures are optional.
To disable the feature during the current terminal session, enter the terminal no history privileged
EXEC command.
To disable command history for the line, enter the no history line configuration command.
Using Editing Features
This section describes the editing features that can help you manipulate the command line. It contains
these sections:
•
•
•
Enabling and Disabling Editing Features
Although enhanced editing mode is automatically enabled, you can disable it, re-enable it, or configure
a specific line to have enhanced editing. These procedures are optional.
To globally disable enhanced editing mode, enter this command in line configuration mode:
Switch (config-line)# no editing
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
2-6
Result
Recall commands in the history buffer, beginning with the most recent command.
Repeat the key sequence to recall successively older commands.
Return to more recent commands in the history buffer after recalling commands
with Ctrl-P or the up arrow key. Repeat the key sequence to recall successively
more recent commands.
While in privileged EXEC mode, list the last several commands that you just
entered. The number of commands that appear is controlled by the setting of the
terminal history global configuration command and the history line configuration
command.
Enabling and Disabling Editing Features, page 2-6
Editing Commands through Keystrokes, page 2-7
Editing Command Lines that Wrap, page 2-8
Chapter 2
Using the Command-Line Interface
(optional)
(optional)
(optional)
Table
2-4. These actions
OL-26520-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
