Cisco Catalyst 2960 Software Configuration Manual page 857
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Chapter 37
Configuring IPv6 ACLs
The switch supports most Cisco IOS-supported IPv6 ACLs with some exceptions:
•
•
•
•
•
•
•
•
•
•
Configuring IPv6 ACLs
Before configuring IPv6 ACLs, you must select one of the dual IPv4 and IPv6 SDM templates.
To filter IPv6 traffic, you perform these steps:
Create an IPv6 ACL, and enter IPv6 access list configuration mode.
Step 1
Configure the IPv6 ACL to block (deny) or pass (permit) traffic.
Step 2
Apply the IPv6 ACL to an interface. For router ACLs, you must also configure an IPv6 address on the
Step 3
Layer 3 interface to which the ACL is applied.
These sections describe how to configure and apply IPv6 ACLs:
•
•
•
•
OL-26520-01
IPv6 source and destination addresses—ACL matching is supported only on prefixes from /0 to /64
and host addresses (/128) that are in the extended universal identifier (EUI)-64 format. The switch
supports only these host addresses with no loss of information:
–
aggregatable global unicast addresses
–
link local addresses
The switch does not support matching on these keywords: flowlabel, routing header, and
undetermined-transport.
The switch does not support reflexive ACLs (the reflect keyword).
This release supports only port ACLs and router ACLs for IPv6; it does not support VLAN ACLs
(VLAN maps).
The switch does not apply MAC-based ACLs on IPv6 frames.
You cannot apply IPv6 port ACLs to Layer 2 EtherChannels.
The switch does not support output port ACLs.
Output router ACLs and input port ACLs for IPv6 are supported only on . Switches support only
control plane (incoming) IPv6 ACLs.
When configuring an ACL, there is no restriction on keywords entered in the ACL, regardless of
whether or not they are supported on the platform. When you apply the ACL to an interface that
requires hardware forwarding (physical ports or SVIs), the switch checks to determine whether or
not the ACL can be supported on the interface. If not, attaching the ACL is rejected.
If an ACL is applied to an interface and you attempt to add an access control entry (ACE) with an
unsupported keyword, the switch does not allow the ACE to be added to the ACL that is currently
attached to the interface.
Default IPv6 ACL Configuration, page 37-4
Interaction with Other Features, page 37-4
Creating IPv6 ACLs, page 37-4
Applying an IPv6 ACL to an Interface, page 37-7
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Configuring IPv6 ACLs
37-3
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
