Displaying Ipv4 Acl Configuration - Cisco Catalyst 2960 Software Configuration Manual

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Displaying IPv4 ACL Configuration

You can display the ACLs that are configured on the switch, and you can display the ACLs that have

been applied to interfaces.

When you use the ip access-group interface configuration command to apply ACLs to a Layer 2

interface, you can display the access groups on the interface. You can also display the MAC ACLs

applied to a Layer 2 interface. You can use the privileged EXEC commands as described in

to display this information.

Commands for Displaying Access Lists and Access Groups

show access-lists [number | name]

show ip access-lists [number | name]

show running-config [interface interface-id]

show mac access-group [interface interface-id]

Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE

Display the contents of one or all current IP and MAC address access lists

or a specific access list (numbered or named).

Display the contents of all current IP access lists or a specific IP access list

(numbered or named).

Displays the contents of the configuration file for the switch or the

specified interface, including all configured MAC and IP access lists and

which access groups are applied to an interface.

Displays MAC access lists applied to all Layer 2 interfaces or the specified

Layer 2 interface.

Configuring Network Security with ACLs

Show Quick Links

Table of Contents

Catalyst 2960-s