Specifying The Physical Address For Controller And Interface Configuration - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Specifying the Physical Address for Controller and Interface Configuration
It includes information about configuring the SPAs in either synchronous optical network (SONET) or
synchronous digital hierarchy (SDH) framing modes. For information about managing your system images
and configuration files, refer to the following:
•
•
•
Specifying the Physical Address for Controller and Interface Configuration
This section describes how to specify the physical location of the SIP, SPAs, and interfaces on the 1-Port
Channelized OC-3/STM-1 SPA and 1-Port Channelized OC-12/STM-4 SPA.
To specify the physical address for controller or interface configuration, use the interface and controller
sonet commands, where:
• slot —Specifies the chassis slot number in the Cisco ASR 1000 Series Routers where the SIP is installed.
• subslot —Specifies the slot of the SIP where the SPA is installed.
• port —Specifies the SONET port number. There is only one port on a 1-Port Channelized OC-3/STM-1
For example, if the 1-Port Channelized OC-3/STM-1 SPA or 1-Port Channelized OC-12/STM-4 SPA is
installed in subslot 0 of a Cisco ASR 1000 SIP in slot 3 of the chassis, the controller configuration address is
specified as controller sonet 3/0/0.
For channelized SPA configuration, the interface address format is: slot/subslot/port:channel-group , where:
• channel-group —Specifies the logical channel group assigned to the time slots within the T1 link.
For more information about identifying slots and subslots, see the
223.
Naming the Interface
Interface names are automatically generated, and the format will be dependent on the mode each particular
linecard is operating on. The name formats of the serial interface created are listed below.
Channelized T3 mode
If framing is SONET or SDH with au-3:
interface serial [slot/subslot/port ][ds3 |ds1 ]:[channel-group ]
SONET Mode
• If framing is SONET and mode is vt-15:
interface serial [slot/subslot/port ].[sts1/vtg/t1 ]:[channel-group ]
• If framing is SONET and mode is CT3
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
292
Configuring the 1-Port Channelized OC-3/STM-1 SPA and 1-Port Channelized OC-12/STM-4 SPA
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Cisco IOS Configuration Fundamentals Configuration Guide
Cisco IOS Configuration Fundamentals Command Reference
SPA and 1-Port Channelized OC-12/STM-4 SPA, therefore the port number is always 0.
Required Configuration Tasks, on page
OL-14127-17
Advertisement
Chapters
Table of Contents
Troubleshooting
