Configuration Examples
Example:
write memory
Step 22
Verify that the running configuration is pointing to the correct node determined in Step 8:
Example:
show running-configuration
Step 23
Make sure that you are on the same network as the Cisco ASR 1000 Series Aggregation Services Router or VPN, and
start a WebEx meeting.
Step 24
Verify that network traffic is traversing the WebEx SPA card on the Cisco ASR 1000 Series Aggregation Services Router
by running the following commands:
Example:
show platform hardware qfp act interface if-name service-engine0/0/0 statistics
show platform hardware qfp act interface if name service-engine0/1/0 statistics
Step 25
Access the SIP console by using the request platform software console attach slot/subslot command.
Configuration Examples
This section includes an example for configuring a Cisco WebEx Node SPA installed in a Cisco ASR 1000
Series Router:
Router# config t
Router(config)# ip nat inside source static 10.200.72.18 192.0.2.1
Router(config)# interface service-engine 1/0/0
Router(config-if)# ip address 10.200.72.17 255.255.255.252
Router(config-if)# service-engine ip address 10.200.72.18 255.255.255.252
Router(config-if)# service-engine default-gateway 10.200.72.17
Router(config-if)# service-engine nameserver 10.100.4.10 10.100.4.20
Router(config-if)# service-engine hostname spawma1 cisco.com
Router(config-if)# service-engine wma-url https://wmabts.webex.com/wmams
Router(config-if)# service-engine wma-passcode spawma1 2b51221d2c08f405913bbee1eb9f6ec6
Router(config-if)# service-engine wma-token 45484b3e-8ea5-41e5-b050-49409006d14e
Router(config-if)# no shutdown
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
380
Configuring the Cisco WebEx Node for the ASR 1000 Series Aggregation Services Routers
OL-14127-17