Configuring The 2-Port Channelized T3/E3 Atm Ceop Spa For The T3 Mode And The E3 Mode - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Configuring the 2-Port Channelized T3/E3 ATM CEoP SPA for the T3 Mode and the E3 Mode
Command or Action
Step 7
Router(config-if-atm-l2trans-pvc-xconn)#
backup peer peer-router-id peer-vcid
{priority peer-priority | pw-class name }
Step 8
Router(config-if-atm-l2trans-pvc-xconn)#
backup delay enable-delay {disable delay
| never}
Configuring the 2-Port Channelized T3/E3 ATM CEoP SPA for
the T3 Mode and the E3 Mode
This section describes how to configure the 2-Port Channelized T3/E3 ATM CEoP SPA. This SPA can be
configured to operate in the ATM mode and the CEM mode. The router creates a logical interface to represent
the mode that the SPA port is configured to run in. An ATM interface or a CEM interface is created for each
T3 port that is configured for the ATM mode or the CEM mode. The interface has the format atm slot /subslot
/port or cem slot /subslot /port, where slot /subslot identifies the SPA slot and subslot, and port identifies the
port. The same port can be configured either in the CEM mode or in the ATM mode.
The following sections provide instructions for configuring the 2-Port Channelized T3/E3 ATM CEoP SPA:
Up to 1000 PVCs and 255 PVPs are supported per SPA for the ATM mode. Up to 576 CEM groups are
Note
supported per SPA for the CEM mode.
Configuring a SPA Port for the T3 Mode
To configure a SPA port for the T3 mode, perform the following steps:
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
492
Configuring the Circuit Emulation over Packet Shared Port Adapter
Purpose
• pseudowire-class name specifies a pseudowire class that includes
the encapsulation mpls command.
Note
The peer-router-id and vcid combination must be unique on the
router.
Configures a backup peer router for providing ATM service if a failover
occurs.
Configures the backup delay parameters.
• enable-delay is the time after which the backup route starts to work
as the primary route. The valid range for the enable-delay is 0 to 180
seconds.
• disable delay is the time after which the backup route will be disabled.
The valid range is 0 to 180 seconds.
• never enables the delay and sets it to never expire.
OL-14127-17
Advertisement
Chapters
Table of Contents
Troubleshooting
