Table of Contents
Advertisement
Positioning parameter
[Pr.25]
Acceleration time 1
[Pr.26]
Acceleration time 2
[Pr.27]
Acceleration time 3
[Pr.28]
Deceleration time 1
[Pr.29]
Deceleration time 2
[Pr.30]
Deceleration time 3
[Pr.31]
JOG speed limit value
JOG operation acceleration
[Pr.32]
time selection
JOG operation deceleration
[Pr.33]
time selection
Acceleration/deceleration
[Pr.34]
process selection
Detailed parameters 2
[Pr.35]
S-curve ratio
Sudden stop deceleration
[Pr.36]
time
Stop group 1 sudden stop
[Pr.37]
selection
Stop group 2 sudden stop
[Pr.38]
selection
Stop group 3 sudden stop
[Pr.39]
selection
Positioning complete signal
[Pr.40]
output time
Allowable circular
[Pr.41]
interpolation error width
External command function
[Pr.42]
selection
*1
This is an irrelevant item, so the set value will be ignored. If the value is the default value or within the setting range,
there is no problem.
CHAPTER 5 DATA USED FOR POSITIONING CONTROL
Position control
1-axis linear control
2-axis linear interpolation
1-axis fixed-feed control
control
2-axis fixed-feed control
3-axis linear interpolation
3-axis fixed-feed control
control
4-axis fixed-feed control
4-axis linear interpolation
control
2-axis circular
interpolation control
3-axis helical interpolation
control
5
99
Advertisement
Table of Contents
Troubleshooting
