Table of Contents
Advertisement
Appendix 6
The following shows the procedure for positioning operation when GX Works2 is used.
Start
Starting GX Works2
Start GX Works2.
Creating a new project
Create a new project.
Adding a module
Add a module for the project.
Configure parameters
and positioning data with
GX Works2?
YES
Setting parameters and auto refresh
Configure each setting with GX Works2.
Programming and debugging
Create and debug a program.
Writing data to flash ROM
Write data to the flash ROM.
Monitoring and testing
Trace waves and locations of positioning
operation.
Starting operation
Monitoring
Monitor the operating status of the LD75.
End
GX Works2 Version 1 Operating Manual (Common)
(1)
GX Works2 Version 1 Operating Manual (Common)
(2)
(3)
Page 738, Appendix 6.1
Page 739, Appendix 6.2, Page 745, Appendix 6.3
(4)
Page 235, CHAPTER 6
(5)
Page 235, CHAPTER 6
(6)
Page 612, Section 13.3
(7)
Page 756, Appendix 6.5, Page 763, Appendix 6.6, Page 765, Appendix 6.7
(8)
(9)
Page 746, Appendix 6.4
For details on the operation method of GX Works2, refer to the following.
GX Works2 Version 1 Operating Manual (Common)
When Using GX Works2
(1)
(2)
(3)
NO
(4)
(6)
(7)
(8)
(9)
Creating programs for parameters and data
Create programs to set parameters and data.
APPENDICES
A
(5)
737
Advertisement
Table of Contents
Troubleshooting
