Table of Contents
Advertisement
An error will occur and the positioning will not start in the following cases. The machine will immediately stop if
the error is detected during positioning control.
When the radius exceeds "536870912 (= 2
which circular interpolation control is possible is "536870912 (= 2
End point address is outside the range of 2147483648 (2
31
1).
(2
Start point address = Center point address
End point address = Center point address
Center point address is outside the range of 2147483648 (2
31
1).
2147483647 (2
(c) Positioning data setting example
• Reference axis, circular interpolation axis, and linear interpolation axis are specified as axis 1, axis 2, and
axis 3, respectively.
The following table shows setting examples when "helical interpolation control with sub point designation (INC
helical right, INC helical left)" is set in positioning data No. 1 of axis 1. (The required values are also set in
positioning data No. 1 of axis 2 and axis 3.)
Setting item
[Da.1]
Operation pattern
[Da.2]
Control system
Acceleration time
[Da.3]
No.
Deceleration time
[Da.4]
No.
Axis to be
[Da.5]
interpolated
Positioning
Positioning
data No. 1
[Da.6]
address/movement
amount
[Da.7]
Arc address
[Da.8]
Command speed
[Da.9]
Dwell time
[Da.10]
M code
*1
Refer to "List of Positioning Data ( Page 152, Section 5.3)" for information on the setting details.
414
Error cause
29
)". (The maximum radius for
29
31
) to 2147483647
31
) to
Axis 1 (reference
axis) setting
example
Positioning
complete
INC helical right
INC helical left
1
0
Axis 2
8000.0m
4000.0m
6000.00mm/min
500ms
10
An error "Outside radius range" (error code: 544) will occur at positioning start.
)".)
An error "End point setting error" (error code: 526) will occur at positioning
start.
Error "Center point setting error" (error code: 527)
Error "Center point setting error" (error code: 527)
Error "Center point setting error" (error code: 527)
Axis 2 (circular
Axis 3 (linear
interpolation axis)
interpolation axis)
setting example
setting example
6000.0m
3000.0m
3000.0m
50
Error code
Setting details
Set "Positioning complete" assuming
that the next positioning data will not be
executed.
Set incremental system, 3-axis helical
interpolation control with center point
designation. (Select clockwise or
counterclockwise according to the
control.)
Specify the value set in "[Pr.25]
Acceleration time 1" as the acceleration
time at start.
Specify the value set in "[Pr.10]
Deceleration time 0" as the deceleration
time at deceleration.
Set the axis to be interpolated (partner
axis).
If the self-axis is set, an error will occur.
Set the movement amount. (Assuming
"mm" is set in "[Pr.1] Unit setting".)
Set the arc address. (Assuming "mm" is
set in "[Pr.1] Unit setting".)
Set the speed during movement. (Set
the composite speed in "[Pr.20]
Interpolation speed designation
method".)
Set the time the machine dwells from
the positioning stop (pulse output stop)
to the output of the positioning complete
signal.
Set this item when other sub operation
commands are issued in combination
with the No. 1 positioning data.
Set the number of pitch for the linear
interpolation axis.
Advertisement
Table of Contents
Troubleshooting
