Table of Contents
Advertisement
(1) Details of areas
• Parameter area: Area where parameters, such as positioning parameters and OPR parameters, required for
positioning control are set and stored. (Set the items indicated with [Pr.1] to [Pr.57], [Pr.70], and [Pr.150] for
each axis.)
• Monitor data area: Area where positioning system or LD75 operation state is stored. (Set the items indicated
with [Md.1] to [Md.48], [Md.50] to [Md.52].)
• Control data area: Area where data for operating and controlling positioning system is set and stored. (Set
the items indicated with [Cd.1] to [Cd.42].)
• Positioning data area (No.1 to 600): Area where positioning data No.1 to 600 is set and stored. (Set the
items indicated with [Da.1] to [Da.10] and [Da.27] to [Da.29] for each positioning data.)
• Block start data area (No.7000 to 7004): Area where information required only when carrying out block No.
7000 to 7004 high-level positioning is set and stored. (Set the items indicated with [Da.11] to [Da.19].)
• PLC CPU memo area: Area where condition judgment values required for special positioning, etc., are set
and stored.
306
Data is backed up
here.
Flash ROM
Parameter area
Positioning data area
(No.1 to 600)
Block start data area
(No.7000 to 7004)
LD75
User accesses
here.
Buffer memory
Parameter area
Positioning data area
(No.1 to 600)
Block start data area
(No. 7000 to 7004)
Monitor data area
Control data area
PLC CPU
memo area
Advertisement
Table of Contents
Troubleshooting
